floor bulkhead C cutouts?
Posted: Sun Feb 19, 2012 7:05 pm
I'm putting on the ST-31 angle brackets that tie the door sills to the
floor bulkhead uprights. I'm wondering whether to also tie in short
doublers at the C cutouts of the uprights. Seems like not doing so is
concentrating strain in the small remaining areas next to the cutouts. Any
reason I should not cover those cutouts? (Hard to imagine I'd want to use
them as wire or hose runs.)
-Ben/ 496R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
floor bulkhead uprights. I'm wondering whether to also tie in short
doublers at the C cutouts of the uprights. Seems like not doing so is
concentrating strain in the small remaining areas next to the cutouts. Any
reason I should not cover those cutouts? (Hard to imagine I'd want to use
them as wire or hose runs.)
-Ben/ 496R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------