#5 Hinge Rear spar for wing Super Rebel/Moose Upgrade
Posted: Mon Feb 20, 2012 2:34 am
I am beginning to pre-build the rear spar in my head. Does the #5 hinge
(wing tip hinge) need to be shimmed to be in the correct position to
minimize/prevent binding. It seem that the hinge will be pulled forward to the
main spar extentions, based on adding up the part thicknesses. Or am I over
analyzing?
I appreciated the discussion regarding the electrical conduit last time I
posted a question.
Thanks,
Paul Lennemann SR 074
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
(wing tip hinge) need to be shimmed to be in the correct position to
minimize/prevent binding. It seem that the hinge will be pulled forward to the
main spar extentions, based on adding up the part thicknesses. Or am I over
analyzing?
I appreciated the discussion regarding the electrical conduit last time I
posted a question.
Thanks,
Paul Lennemann SR 074
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------